1979 Baba 3535ft

Hull: Laminated fiberglass with a full keel, double-end design with faux plank seams. The hull is stiffened with tabbed plywood bulkheads and laminated ribs. Keel: Encapsulated ballast, 8000lbs reported

Decks: Laminated fiberglass with a wood (type unknown) core. The deck is covered with a teak overlay. The cockpit is integral with the deck unit and has two scuppers teed to a single ball valve, above waterline. 

 Cabin/House: Laminated fiberglass with a wood core and molded non-skid, integral with the deck. 

 Rudder and Steering: Fiberglass and foam cored blade with a stainless post, supported on a bronze heel fitting. The post enters through a fiberglass tube with flex hose coupler and a bronze gland. There is an upper bearing. Wheel to wire steering with an emergency tiller stored.  

2001 Yanmar 4JH3E - 56HP FWC diesel

App 1250 hours

SS 1 1/4" shaft

PSS shaft seal

16RH16 three-blade propeller 

twin lever engine controls on pedestal 7 knot cruise at 1800 rpm burning 1 gph

50 gallons fuel in aluminum tank

Two 100 gallon SS water tanks

Stainless holding tank with deck pump out and Y valve

DC Batteries: (4) Group 29 lead acid (new)

Location and Installation: Set in battery box bottoms below the quarter berth.

Wire: Stranded copper

Switches: Guest Panel: Breakers Cabin Lighting: 12vdc overhead and side lamps throughout Navigation

Lighting: Rail and mast head Tri-Nav

Bilge Pumps: Jabsco pump set up and out of bilge, auto and manual override

Other DC Equipment: 12vdc outlets AC Shore Power Connection:

30 Amp Smart Plug connector and cord Panel and Wiring:

Break panel with polarity alarm, stranded copper wiring.

 Charger and/or Inverter: Pro Mariner 20 amp charge, small inverter plugging into the 12vdc outlets.

AC Equipment: Hot water heater, outlets.  

Sea green ultrasuede berth cushions; accommodations for 5-6 with a very comfortable layout including oiled teak interior and varnished teak and holly sole. Chain locker forward followed by vee berths with a filler, and hatch overhead. Next aft is an enclosed head to port with dual access doors with a new W.C. with new hoses, sink, shower, and marble counter top. Opposite the head is a seat with hanging locker behind. Main salon has port and starboard settees, a drop leaf teak table, teak butterfly hatch overhead, numerous lockers, bookshelves and drawers. Dickinson "Newport" charcoal/wood cabin heat stove, mounted on starboard main cabin bulkhead. Further aft to starboard is a nav table and quarter berth, and wet locker. To port is a U-shaped galley with numerous lockers. Access to the engine is under the companionway sole.

 Propane stove/oven new in 2018. Hot and cold pressure water system (new water hoses). Dual S/S sinks.

Autohelm ST 5000 autopilot.

Garmin GPS Map 210.

5" Ritchie powerdamp compass.

 Standard Horizon Intrepid VHF. with RAM mic

Questus mount on backstay.

Furuno 1st watch wireless radar that works Apple Ipad or Iphone and mount for viewing ipad from the helm for chart plotting and radar.

Cutter rig w/ 2018 Bohndell mainsail with a Dutchman flaking system, 2000 Yankee jib by Doyle, 1996 staysail reworked in 2018. New 2009 Cruising gennaker with sock, by Sperry Sails, Marion, MA. Schaefer 2100 Roller furling system. Wood mast stepped on keel. Barient winches and aluminum spinnaker pole. Mainsheet traveler, mounted forward of Dodger. S/S inboard sail tracks and tracks mounted on trunk cabin.

Sunbrella Tan Dodger and dodger grab rails

Sunbrella Bimini

Sunbrella Mainsail cover

Anchor Windlass - Maxwell HRC10 w/ remote control

5 lb CQR with new 3/8" BBB chain lead and 5/8" nylon rode

Brass 5" Boston clock & barometer

3 fire extinguishers

Flares

10 life jackets

6" brass bell

Life ring

Radar reflector

Docklines

Rod holders.

 Boat hook

Teak folding swim ladder

BBQ grill

S/S 10.5 gallon hot water heater - Electric and/or Engine heat

Canvas covers for three hatches

Halogen portable searchlight

Sea Swing gimballed sterno stove

Brass Aladdin kerosene lamp