1955 Traditional 9 ton Hillyard Cutter
- View Full Specifications
9 Ton Hillyard Cutter
- Engine/Fuel Type:
- Single / diesel
- Located In:
- Dartmouth, Devon, United Kingdom
- Hull Material:
- Last Listed Price:
- £ 10,000 (US$ 13,184)
9 ton Hillyard built in 1955. Converted to a bermudan cutter with a bowsprit and roller furling jib. 4 berths including a large double in the aft cabin and 2 saloon settee berths. Beta diesel fitted new in 2008. New standing rigging fitted 2008. She appears to be a solid yacht but needs some cosmetic attention. Full list of equipment and electronics aboard. Perfect small cruising boat, very safe and comfortable.
Wooden Ships International Yacht Brokerage
Contact: Richard Gregson on 01803 833899/ 07886081657
Please contact Richard Gregson at +44 (0)1803 833899
Additional Specs, Equipment and Information:
Builder: Hillyards of Littlehampton
Designer: David Hillyard
Flag of Registry: United Kingdom
LOA: 37 ft 0 in
Beam: 8 ft 6 in
LWL: 28 ft 0 in
Length on Deck: 32 ft 6 in
Minimum Draft: 4 ft 6 in
Maximum Draft: 4 ft 6 in
Total Power: 43 HP
Engine Brand: Beta Marine
Year Built: 2009
Engine Model: 4 cylinder
Engine Type: Inboard
Engine/Fuel Type: Diesel
Drive Type: Direct Drive
Engine Power: 43 HP
Cruising Speed: 6 knots
Fresh Water Tanks: 2 (24)
Fuel Tanks: 1 Stainless steel (22)
Number of single berths: 3
Number of double berths: 1
Compass - Helm compass
CD player - stereo system with speakers
Radio - DSC
GPS - Raymarine
Radar - fURUNO
Depthsounder - Raymarine
Plotter - RAYMARINE CHART PLOTTER
Log-speedometer - Trailing walker log
Storm jib - sANDERS
Spinnaker - Spinnaker pole
Heating - Taylors paraffin stove in the saloon with Eberspacher diesel fired heating system in saloon and aft cabin.
Battery charger - 3 x 12 volt batteries for domestics and engine starting. Installed shore power system with charging
Oven - Origo 2 burner spirit stove
Marine head - Jabsco sea toilet, discharges directly overboard.
Refrigerator - 12v fridge mounted
Manual bilge pump - 2
Electric bilge pump - 1
Shore power inlet
Liferaft - Avon 4 man
9 ton Hillyard Cutter
Wooden Ships Comments on this 9 ton Hillyard cutter
9 Ton Hillyard built by Hillyards in 1955. Standard lines of the 9 tonner with a centre cockpit and canoe stern. The rig has been altered to a cutter with a bowsprit and a jib on a roller furling system.
Thorough refit in 2008/2009 when a new Beta diesel was fitted, keel bolts checked and standing rigging replaced shortly after. She has recently had a period ashore for paint and antifoul and has been sailed this autumn.
4 berths including a large double in the aft cabin. Thorough list of electronics and equipment, everything she needs to go cruising. Major items such as engine, sails and rigging have been replaced in recent years, she just needs a new owner who can tidy up the cosmetics a little.
Length on deck 32’6″
Length Overall 37′
Length Waterline 28′
Thames Tonnage 9TM
Planked in 3/4″ mahogany all copper fastened to steam bent oak timbers.
Grown oak floors across the centreline.
External iron ballast keel with steel keel bolts, sample bolts last drawn in 2009. Some internal iron ballast.
T&G pine decks sheathed in epoxy cloth and painted in deck paint.
Painted mahogany coachroof coamings and sheathed plywood coachroof deck.
Typical deep centre cockpit with varnished mahogany coamings. Wheel steering mounted on aft bulkhead of cockpit with hydraulic coupling to the rudder.
Bermudan cutter rig on deck stepped painted wooden mast.
Varnished wooden roller reefing boom and varnished bowsprit.
Stainless steel standing rigging, 7 years old, to internal stainless steel chain plates.
Furlex roller furling jib at bowsprit end.
Mainsail, staysail, jib and storm all by Sanders sails and less than 10 years old, all in good condition.
Cockpit sheet winches, mainsheet self tailing winch and mast winch.
Beta Marine 43hp 4cyl diesel installed new in 2009. Only 100 hours running.
Single lever controls with stainless shaft to a centreline 4 blade feathering bronze propeller.
6 knots cruising speed at 1.25 litres/hr
100l stainless fuel tank in starboard cockpit locker
2 separate water tanks with total of 220l fresh water.
3 x 12 volt batteries for domestics and engine starting. Installed shore power system with charging
Aft cabin with double berth to port. Slightly altered from usual Hillyard layout with cupboards on the starboard side meaning the berth is solely a large double.
Heads compartment on the port side with a Jabsco sea toilet, discharges directly overboard.
Steps down from the cockpit into the main saloon with a galley to port. Origo 2 burner spirit stove with a single stainless sink and pressurised cold water. Various storage cupboards, shelves and work top space.
Settee berths either side with a centreline dropleaf table. Storage cupboards and shelving space at forward end of the saloon.
Taylors paraffin stove in the saloon with Eberspacher diesel fired heating system in saloon and aft cabin.
Centreline passage going into the forecabin. Storage area to port for warps, fenders etc. The original berth to starboard has been altered and now has a 12v fridge mounted in it. Could be reinstated as a berth.
Full specification and details available upon request
These particulars have been prepared in good faith from information provided by the Vendors and are intended as a guide, Wooden Ships cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. The Purchaser should instruct his agent or surveyor to validate all details as necessary and satisfy himself with the condition of the vessel and its equipment.
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Other Boats from Wooden Ships
Luke Powell Gaff Cutter
Southampton, Hampshire, United Kingdom
Gaff Cutter Yacht
Brighton, East Sussex, United Kingdom
Colin Archer Gaff Ketch
Luke Powell Gaff Cutter
Falmouth, Cornwall, United Kingdom
Danish gaff ketch
Auckland, New Zealand
Bristol Channel Pilot Cutter
Bristol, stateprovince.E031, United Kingdom