2009 28' SeaWorthy (BHM)

OVERVIEW

These fabulous, very capable, dry, stable and extremely safe Lobster Cruisers, have been built by Steve Law, Master Builder and owner of SeaWorthy Marine, since 2000.

In the past eight years, a total of 52 boats have been launched, and there have been absolutely no structural or mechanical issues with a single one. So, if you are currently exploring your options among DownEast builders, please consider a new 28' SeaWorthy, with 315hp Yanmar power.

For your review, here are the costs and optional extras:

NEW 2009 28’ SeaWorthy Lobster Cruiser
(New Build Cost Estimate March 10th, 2009)

(The prices indicated below are valid as of the above date. Material costs and other construction expenses not under the control of the builder, may increase or decrease this estimate. Projected build time is approximately eight to ten weeks after hull and house arrive at shop in Kennebunk.)

STANDARD EQUIPMENT

*Hull: solid fiberglass, white or gray gelcoat finish; white cored lobster style or full house with white interior gelcoat finish
*Windows: rubber-set fixed windows; open starboard side
*Berths: 8’ V-berths; small opening hatch on housetop; two portlights in berthing area
*Running Gear: PSS shaft seal; SS shaft; SS rudder; bronze 4-blade propeller; two 65 gallon welded polypropylene fuel (diesel only - gas tanks are aluminum)
*Decks: 1” plywood deck glassed, sealed with non-skid applied; SS cleats and chocks; bow spray rail; quarter guard spray rails; PVC edge combing; PVC handrails on cabin and house tops; scuppers with anti-backwash flaps
*Safety: USCG approved navigation lights.
*Engine: Yanmar 6LTA-STP 315hp Diesel Engine with 2-year warranty.
*Transmission: ZF 630A Gear 2:1 reduction; 1-yr warranty.

TOTAL COST - BASE BOAT: $119,000

OPTIONAL EQUIPMENT
*Trolling Valve for ZF 630A Gear $ 600
*Muffler and all components $ 800
*Saltwater Washdown System, 70psi $ 550
*Halogen Deck Lights (2) $ 250
*Wynne aluminum-framed windows; 2 front opening; 1 port slider $ 2,500
*Bomar trunk hatch 19x19” $ 650
*Rocket Launcher, 6-pole anodized aluminum $ 1,200
*Marine Head; holding tank, platforms, mounts, Y-valve, deck fitting for pumpout; fw hookup; hoses $ 1,400
*Console Helm Station (forward tilting for access) $ 1,100
*Bow Rail, 3/16” Stainless Steel $ 1,800
*Shore Power with Marine Panel, and 2 GFI outlets $ 900
*Battery Charger – 20amp $ 450
*Pressure Freshwater System; custom tank, pump, mount, hoses, fittings, vent, fill $ 1,000
*Power Outlet, 12-volt next to helm $ 100
*Full Winter Back; 2 sliding doors; 3 fixed windows $ 2,800
*Tackle Box/Storage Cabinet; 5’ long with 1 custom tackle box on portside of wheelhouse $ 600
*Dyna-Plate, complete bonding system $ 500
*Interior overhead handrail; 6’ stainless steel $ 250
*Livewell pump, fittings, seacock, filter, hoses – Overboard discharge at transom air box $ 500
*Mahogany trim package $ 1,500
*Full size upper berths $ 500
*Stainless Steel Handrails – cabin top and trunk top $ 600
*Stainless Steel Trim Package (for all PVC trim) $ 500
*Storage Cabinets – Port side, Stbd side, below in cabin $ 1,500
*Anchor Locker – SS rope hawsepipe; floor; drain; access hatch; all gelcoated inside $ 600
*Cockpit Storage Lockers – under deck, port & stbd, with 2 24” x 16” Anchor flush aluminum hatches $ 900
*Rod Holders – 9 standard; 2 swivel; stainless steel $ 1,300
*Polyfair Interior – grind, sand, 3 coats of finish gelcoat in cabin and wheelhouse $ 2,200
*Cabin Heater – 40,000 BTU $ 750
*Canvas Starboard side 2-piece (estimate only) $ 600
*Cushion Covers – (6 pieces) Sunbrella frabric, 3” thick dense foam $ 2,200
*LED lighting under washrails $ 200
*Back-up Bilge Pump with bilge alarm $ 350
*Transportation from Builder’s Yard to Marina – launch for seatrial $ 350

TOTAL COST: $151,000