Bruckmann 50 Specifications
STRUCTURE
- Fiberglass roving & unidirectional reinforcements over foam floors with limber holes
- Deck flange bolted & bonded to hull flange
- High density foam floors in way of mast & engine beds with extra reinforcement
- Cast lead alloy ballast
- Stainless steel keel bolts cast in place with stainless steel nuts & washers
- Keel bedded to sump with epoxy
HULL
- Vinylester resin throughout
- Single piece Core Cell cored fiberglass molding
- Extra reinforcing as required
- Core phased out in way of all thru hulls, struts, shaft log, rudder port & centre line
- Molded keel sump with increased laminate
- Awlgrip painted topsides & boot stripe
- Externally fastened 16,000 lb. cast lead ballast
DECK
- Single piece Core Cell cored fiberglass molding with non skid pattern on all working surfaces
- Core phased out in way of all deck fittings
- Aluminum backup plates on thru deck hardware
- Two tone Awlgrip & gelcoat finish
- Awlgrip painted non skid
- 2 large storage lockers in cockpit
- Oiled teak nosing on house sides & front
COCKPIT
- Large hinged cockpit transom door
- Full width teak swim platform with swim ladder
- Two sealed & self draining lockers
- Three sculpted seats for cockpit steering
- Pedestal with angled guard & brake
- Table with folding leaves, grab rails, built-in insulated cooler, waste bin & stainless steel foot rests
- Single lever engine controls
- Engine gauges with start & stop switches at both stations
DECK HARDWARE
WINCHES
TRACKS, LEADS, DECK BLOCKS
HATCHES, VENTS, PORTS, RAILS
CLEATS & CHOCKS
SPARS & RIGGING
- Awlgrip aluminium furling mast
- Masthead rig
- Harken furling/schafer
- Double airfoil shaped spreaders
- Double lower shrouds
- Aluminium mast step
- White Awlgrip boom
- Solid boom vang
- Bobstay
- All rope running rigging, colour coded
- 2 mainsheets
- 2 Genoa Sheets
- Flag & burgee halyards
- 3 internal halyards
- Boom with welded ends, four internal sheaves, & adjustable outhaul car
STEERING
- Balanced fiberglass foam filled rudder with 41/2" stainless steel shaft & stiffeners
- Custom fiberglass pedestal
- 44" diameter stainless steel wheel
- 6" Ritchie compass with stainless steel cover
- Stainless steel emergency tiller
- Inside steering station with compass, full engine instrument panel, controls & chart area
ENGINE & DRIVE SYSTEM
- John Deere 135hp. diesel with C-type instrument panel
- 1 3/4" diameter aquamet propeller shaft
- 3 blade propeller
- FRP shaft log & bronze stuffing box
- GROCO raw water engine strainer
- (2) 125 US gallon aluminium fuel tanks with vents
- Duel Racor fuel filters with sight globe & alarm
- Engine room sound insulation
- Blower engine room ventilation
- Hinged engine access
- Stainless steel thru transom exhaust
- Coast Guard approved exhaust hoses
- Waterlift Muffler
ACCOMMODATIONS
- Standard finish white bulkheads with satin varnish trim & doors
- Main bulkheads formica covered marine plywood fiberglassed to hull & deck
- All other bulkheads & faces marine grade plywood fiberglassed to hull & deck
- All exposed interior fiberglass in locker interiors covered with teack, cedar, or gelcoat
- All interior joiner work & trim satin varnished
- Varnished teack & holly sole
- Removable overhead panels finished in satin white
- Shaped varnished valence hand hold at house side
- 5" foam upholstered cushions in main cabin & 6" foam in staterooms
- All latches, hinges, catches & pulls brass or bright chrome or stainless steel
- Stainless steel sink in head & separate shower stall
- Chart table with hinged top
- Corian counter tops in galley & heads
REFRIGERATION
- 12 volt refrigeration
- Seperate freezer & refrigerator with top & side access
- Molded fiberglass box with 4" foam insulation
PLUMBING
- Pressure water with hot & cold faucets in heads & galley accumulator tank & filter
- 11 gallon water heater with 110 V & engine heat exchanger
- Shower with molded sump, sump pump & telephone type shower head
- Hot & cold cockpit shower
- Foot pumps for fresh & salt water in galley
- 2 stainless steel water tanks, 120 US gallons per, with level gauges
- Under mounted stainless steel sinks in heads
- Icebox drain pump
- Rigid colour coded PVC plumbing & couplers
- 2 Raritan manual heads with (2) 40-gallon stainless steel holding tanks
- Holding tank with overboard discharge & 12 volt macerator
- All below water through-hulls fitted with Marelon seacocks
BILGE PUMPS
- 1 #10 Whale "Gusher" manual bilge pump mounted in cockpit
- 1 Rule 2000 electric bilge pump with auto float switch
PROPANE
- 3 burner Force 10 stainless steel stove with oven
- (2) 10lb. aluminium propane tanks with regulators
- Propane storage in vented aft locker
- Solenoid propane shutoff valve with remote switch
- All hoses & connections to Coast Guard requirements
ELECTRICAL
EXTERIOR LIGHTS
- Navigation lights on bow pulpit, stern light on stern push pit
- Steaming, foredeck, masthead & spreader lights on mast
- Lights at compass locations
INTERIOR LIGHTS
- Overhead dome lights in staterooms, main cabin, galley, heads, pilothouse & engine space
- Directional reading lights in staterooms, main cabin & pilothouse
- All lights "Cantaloupi" or "Danish Cabin"
12 VOLT SYSTEM
- All wiring sized & color coded to ABYC specs.
- Navigation lights on masthead, foredeck, & stern light on aft deck
- Steaming, foredeck, masthead & spreader lights on mast
- Lights on compass
- (1) x DS115 & (2) x 8D gel cell batteries
- 2 explosion proof master battery selection switches
- 12V D.C. custom distribution panel with 30amp double pole shore power main breaker, A.C. line voltage meter, polarity indicator
- 110 volt outlets in galley, head & dinette
- 30amp. battery charger
- 5 chrome overhead lights in galley, dinette, head & forward stowage area
- 3 chrome swivel reading lights in dinette, nav. area, & aft bunk
- Directional light at chart table
Back to the Bruckmann 50
International Marine Management Inc.
|
901 Fairview Avenue N Suite #C-150 Seattle, WA 98109, USA |
Toll-free 877-213-1463 Tel (206) 282-4262 Fax (206) 464-4262 Email Us |
