Hull, Deck and Hardtop construction
Hand laid, moulded fibreglass hull and deck GRP construction. Solid fibreglass hull bottom, keel and chines.
Hull stiffened with longitudinal and transverse stringers, foam cored and GRP sheathed, supported by transverse bulkheads and deck.
Independent compartments throughout hull structure for safety.
Watertight stepped collision bulkhead and anchor locker forward.
Main bulkheads and forward floor is resin infused composite construction using foam core with layers of fibreglass laminate for weight efficiency.
Hull antifouled in black, epoxy undercoat, Propspeed to Zeus® drives and propellers.
Non-skid finishes on foredeck and side decks.
Hull and Deck Fittings
Stainless steel protection plate under the bow on the hull.
Four (4) Manship round opening portholes in hull side- stainless steel.
Four (4) moulded fixed large port lights with glass.
Three (3) Manship round deck hatches on foredeck with stainless steel frames.
Bow Rail on main deck built in 60mm elliptical stainless top rail, 32 mm upright stanchions, solid mid rails at 25mm forward with white plastic covered stainless steel wires running aft. A burgee holder is fitted on the forepeak of the bow rail.
Two (2) custom stainless steel cleats for foredeck, one on each side. Two (2) stainless steel custom fairleads on toe rail, one each side.
Four (4) stainless steel cleats amidships, two (2) each side as springer cleats. Each affixed atop the teak bulwark capping.
Two (2) custom stainless steel cleats on aft deck quarters, one (1) on each side.
Custom fairleads to each cleat aft.
Forward curved 12mm glass windscreen incl standard windscreen cover.
Two (2) fuel fillers and one (1) fresh water deck filler with stainless steel vents.
One (1) dockside pump-out point for black water.
Fresh water deck wash points one (1) on aft deck and one (1) in anchor locker.
One (1) sea water deck wash point in anchor locker.
LED courtesy lights for exterior cockpit and side decks (warm white).
Warm white LED exterior ceiling lights.
LED navigation lights (Port &Stb).
Dual Trumpet air horn.
Dark tinted tempered glass in 8mm for side windows.
One opening side window each side of the saloon.
Dark tinted tempered glass and stainless steel for aft deck bulkhead with sliding door and opening outward hopper window- all curved vertically for aesthetic appeal.
Hard top with electrically operated sliding Sunroof and heat resistant glass panels.
Sun bed on foredeck with white vinyl cushion with closed cell foam, 40mm elliptical stainless steel surrounding grab rails, two (2) drink holders and sunbed folds up for lounge position.
22mm natural Teak bulwark capping rail -not varnished as standard.
Moulded GRP mast for all aerials and lights. Also accommodates standard
GPS aerial, std docking light, optional radar and optional TV Sat dome.
Painted to match the hull as standard (colour is an option).
Stainless steel anchor light bracket.
Anchor and Mooring Equipment
Custom stainless steel high quality bow roller with chain stop, bow plate and anchor launch system.
Electrical 24V windlass, vertical chain anchor winch with rope and chain capstan.
Chain capstan of the winch is recessed below the deck hatch level.
Windlass handheld lanyard remote control at bow for up/down control.
Windlass remote at helm for winch control and chain counter.
One (1) 35kg stainless steel anchor.
60m of 10mm galvanized anchor chain.
Anchor locker compartment split for chain, lines and fender stowage.
Two (2) anchor locker hatches with positive lock stainless steel catches.
4 Fenders, 4 mooring lines and boat hook.
Teak laid swim platform including hull sponsons with fixed height sections each side including 60mm stainless steel rub rail. Centre section of swim platform has an electro-hydraulic high / low mechanism (max capacity 200KG) to aid in dinghy launch and retrieval.
High quality stainless steel swim ladder housed in a locker on the swim platform.
Built in handheld shower with hot and cold water supply.
3.0m RIB dinghy included and fitted in the garage (no outboard included).
Garage will close with dinghy and outboard fitted.
Electric opening mechanism for tender garage door.
Electric winch retrieval system (24V DC) for easy return of the dinghy back into the garage.
Roller system and nylon runners to suit 3m RIB inflatable.
Internal 24v DC LED lighting and 24v DC floodlight fitted.
Cockpit storm covers
Clear Strata glass side curtains
Cockpit awning (Euro style)
Cockpit awning -fixed 3/4 size
Full cockpit awning on 2 stainless steel posts
Breezeway windscreen cover
Side window covers in Breezeway
Cockpit upholstery in Sunbrella
Forward sunbed cover
Cockpit table cover
Cockpit seat cover