LOA 18.80 mt
Beam 5.20 mt
Draft 1.50 mt
Fuel tank 5.000 Lt
Water tank 1,5 mc
Engines 2 x 575 Hp CAT
Displacement 26 Tons
HULL AND DECK STRUCTURE
The boat will be certified CE-A
The hull will be in reinforced fibreglass polyester isoftalic of the best quality .
In order to avoid osmosis problems the first two layers of fibreglass will be done with vinylester resin ( resin completely waterproof ).
The hull will be reinforced inside by means of a grid of longitudinal and transversal reinforce called girders and frames . This structures will be used also for the construction of the structural tanks of fresh water , grey waters and seawage waters improving the strenghtness of the hull.
The deck and the hard top will be done in reinforced fibreglass with a core foam ( sandwich ). The sandwich gives rigidity to the surface of the deck without improving its weight and in addition gives a good insulation against the noise , heat and condense .
The cockpit and the aft platform are covered with solid teak wood 12 mm thick .
ENGINE ROOM INSULATION
The insulation is made with two lay of high density rockwool with interposed a sheet of lead 6/10 mm , in order to have the best insulation against heat and noise.
SECURITY AND FIRE FIGHTING EQUIPMENT
All the equipment is installed according to the rules of Rina Naval Register.
-N.1 centrifugal elettric pump for either bilge and fire fighting service (chain washer also)
-N.1 emergency bilge hand pump
-N.2 emergency bilge suction by means of the engine sea water pumps .
-Piping in copper
-N.4 submersible bilge pump with automatic floating switch and high water level allarm transmitted on the pilot house console. ( One each watertight compartment ).
-N.6 powder fire fighting handle bottle
-Fixed CO2 plant with shut off system for air ventilation and fuel.
Predisposal for subsequent installation of retractable gangway.
Predisposal for subsequent installation on fly bridge of elettrohydraulic crane for dinghy or jet-ski, 450 Kg .
-Electric windlass 2000 W , mod. Leopard Lofran’s with barbottin for a 100 Mt chain 12 mm .
-N.1 Capstan 1000 W on the cockpit .
-Swim ladder manual .
-N.2 suspended rudders in the propeller flow.
-Elettroydraulic servoassisted steering pump mod. BCS
-Autopilot mod. FURUNO or RAYTHEON
-Steering wheel on the pilot console.
-Piping in copper
-Hydraulic cylinder in the lazzerete .
PORTHOLES , WINDOWS AND DOORS
-N. 14 Oval portholes in stainless steel and safety glass.
-N.2 fixed large windows located in the owner cabins, drawing to be supplied later
-Windows in safety glass with two sliding windows on the sides .
-Rear saloon door in four sector, two of them in the middle to be opened sliding.
FRESH WATER SYSTEM
-Structural fibreglass tank for 1.100 Lt.
-Fresh water inlet located on the aft of the boat.
-N.2 fresh water pumps (only 1 working the other one is for spare)
-Piping in PVC and alluminum.
-N.1 water heater 80 Lt.
-Each toilet mod. “Saninautico” is totally independent from the others and very silent.
-A structural Seawage tank is fitted on the bottom of the hull , owner has the possibility to send the exhaust water to the tank or directly to the sea . To pump out the tank a “black water pump “ is fitted , it is possible to pump out the tank directly to the sea or to the pier .
-The toilet can be used either with sea water or fresh water.
The air conditioning is fan coil type CLIMMA, the two main compressors are located in the engine room and each cabin has one or more fancoil depend on its size . The total refrigerating capacity of the plant is 40.000 BTU , the fancoil are located in order to avoid condensate water leaks and noise .
ENGINE ROOM VENTILATION
The engine room is ventilated by means of two reversible fans of a capacity 20 % higher that what required by the engine supplier .
The electric plant is divided in two sections:
-220 V AC currents for air conditioning, charge batteries, waterheater, sockets etc.
-24 V CC for lights, nav. lights, pumps, windlass etc.
The main control box is located in engine room and it has all the necessary switches, fuses, relays, voltmeter etc , necessary for its functions.
In the saloon is located a secondary panel with all the amperometer and voltmeter, necessary for the remote control of all the machineries.
Each cabin has its own fuse box, this allows the rest of the boat to be used even if there is a problem in one cabin.
220 V CIRCUIT
-The 220 V 50 Hz alternate current is supplied by two shore power sockets or by the 18 Kw Generator .
-Circuit breaker on each circuit .
24 V CIRCUIT
-N.1 group of batteries 400 Ah for engine start .
-N.1 group of batteries 800 Ah for services supply .
-N.1 Battery charger 100 Ah for service .
-N.1 Battery charger 60 Ah for engines .
-N.2 alternator driven by the engine 80 Ah each .
12 V CIRCUIT
-N.1 battery 12 V 80 Ah for generator start
-N.1 24V-12V converter for electronic instruments .
-Radar 48 Miles
-Engine room under video control by means of 4 cameras and one screen .
-The above instruments except the video control shall be RAYTHEON or FURUNO integrated system.
N.1 electric bow thrusters 18 Kw.
-Saloon plant with 32 “ TV , DVD stereo HI-FI with Dolby Surround . TV installed on sliding mechanism to be recessed in the cupboard .
-Downstairs saloon with same plant as above.
-TV antenna Connexus omnidirectional
-N.1 car stereo with CD in each cabin .
-N.2 CAT engines 575 Hp
-N.2 shaft 60 mm in high resistance steel V174
-N.2 bronze struts
-N.2 shaft seal in graphite installed on a bronze pipe .
-N.2 four blade propellers of adequate dimension
The engine exhaust are underwater in order to reduce the noise .
When the boat is in idle condition the exhaust goes automatically in atmosphere through
the transom , by means of a by-pass and raw water cooled noise muffler
The cabins lay out can choosen by three different versions according to the owner’s needs.
All the material to be used in the interior decoration such as : wood essence , leather, tissues, moquette, marbles etc. can be choosen by the samples available in the shipyard “atelier “.
The galley will be equipped with the following items :
-N.1 ceramic cooking plate 4 pl.
-N.2 stainless steel sink
-N.1 oven combi with microwave
-N.1 refrigerator + freezer 260 Lt