A nicely built and well maintained example of this Robert Tucker design, recently re-engined and offered for sale in nice condition. The ketch rig is flexible and easily managed, and the moderate draft makes her ideal for exploring the shallow waters of the East Coast and beyond.
Viewing by appointment through our Suffolk Office 01473 659 681.
Additional Specs, Equipment and Information:
Builder: Bridge Boats
Designer: Robert Tucker
Hull Shape: Monohull
LOA: 33 ft 0 in
LWL: 30 ft 0 in
Maximum Draft: 4 ft 6 in
The layout offers five berths in two cabins. In the forward cabin, two settee berths. Removable table. Separate heads compartment to port with marine toilet and washbasin. Chart table to port with pilot berth under. Galley to starboard. Origo gimballed two burner spirit cooker with oven. Stainless steel sink with hot and cold pressurised water system (7 gallon calorifier). 50 gallons freshwater capacity. Refrigerator. Access to the aft cabin, with two single berths, is via the centre cockpit.
Located under the cockpit, Nanni 3.100HE three cylinder 29hp diesel engine, installed new in 2004. Electric start. Freshwater cooled via heat exchanger. Shaft drive to three bladed propeller. Rope cutter. 20 gallons fuel capacity giving approximately 200 miles range at 5.5 knot cruising speed. Maximum speed under power 7.5 knots. Single lever control. The engine has completed some 150 hours running time since new.
2 x 12 volt batteries
240 volt shorepower system
Spars & Sails
Ketch rigged. Anodised aluminium masts and booms. Stainless steel standing rigging (2004). Removable inner forestay. Terylene running rigging. Slab reefing mainsail. Plastimo headsail furling system. Spinnaker pole. Two Gibb self tailing sheet winches. Two halyard winches.
Cruising chute - 2011 - as new
Danforth and Delta anchors with chain
Bruce kedge anchor
Sail covers - 2012
Cockpit spray dodgers
Removable boarding ladder
Full winter cover - 2008
Various warps and fenders
Echomax depth, boatspeed and log
Nasa Clipper windpseed and direction (2006)
DSC VHF radio
Garmin 120 GPS
Masthead and deck level navigation lights
Three fire extinguishers
Cockpit harness attachment points
Manual bilge pump
Electric bilge pump
Honda 2hp outboard motor
Built by Bridge Boats Ltd in 1970 to a design by Robert Tucker. Agba strip planked hull on mahogany framing. Sheathed marine plywood deck with painterd non-slip and varnished coamings. Cast iron fin keel (bolts renewed 2011). Centre self draining cockpit. Skeg hung rudder. Wheel steering.
The company normally acts as broker for the vendor who unless otherwise stated is not selling in the course of a business. Whilst every care has been taken in the preparation of these particulars the correctness is not guaranteed and they are intended as a guide only and do not constitute a part of any contract. A prospective buyer is strongly advised to check these particulars and where appropriate and at his own expense to employ a qualified marine surveyor to carry out a survey and/or to have an engine trial conducted which if conducted by us shall not imply any liability on our part.